Blend Overcurrent (Active)

BLEND OVERCURRENT (ACTIVE)





For a complete wiring diagram refer to the Wiring Information Electrical Diagrams

- When Monitored:
When actuator movement is requested.

- Set Condition:
This DTC will set if the A/C - Heater Control Module detects an excessive current draw on any of the door driver circuits while attempting to drive this actuator. Only one overcurrent DTC can set per ignition cycle.





RUN THE ACTUATOR CIRCUIT TEST

View repair

Repair

- With the scan tool, perform the Actuator Circuit Test. Read the Actuator Circuit Test message(s). Return to the symptom list and choose the symptom(s).
- If two or more drivelines are shorted together when running the Actuator CKT Test, the scan tool may display Actuator CKT Test Passed even though Overcurrent DTCs are active. If this occurs, refer to symptom Act CKT Test Passed, Overcurrent DTCs Active.ACT CKT Test Passed, Overcurrent DTC's Active
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test.