MEM-CAL

MEM-CAL

NOTICE: The ignition should always be off when installing or removing an ECM connector.

Remove or Disconnect

1. ECM from passenger compartment.

2. MEM-CAL access cover.

3. MEM-CAL removal.

Important: Using two fingers, push both retaining clips back away from the MEM-CAL at the same time. Grasp the MEM-CAL at both ends and lift up out of the MEM-CAL socket. Do not remove the cover of the MEM-CAL. Use of unapproved MEM-CAL removal methods will cause damage to the MEM-CAL or MEM-CAL socket.






Inspect






1. "Broadcast code" for proper calibration.






2. For alignment notches of the MEM-CAL and carefully set aside. Do not open the MEM-CAL.

Install or Connect

1. MEM-CAL in MEM-CAL socket.

Important: Press only on the ends of the MEM-CAL Small notches in the MEM-CAL must be aligned with the small notches in the MEM-CAL socket. Press on the ends of the MEM-CAL until the retaining clips snap into the ends of the MEM-CAL. Press the clips into the side of the MEM-CAL until they snap into place. Listen for the click. Do not press on the middle of the MEM-CAL; only on the ends.

2. Access cover on ECM.

3. ECM in passenger compartment.

4. Connectors to ECM.

5. Perform "Functional Check". ECM/MEM-CAL Functional Check