Upper Transverse Link With Retaining Bracket and Vehicle Level Control System Sensor Assembly Overview

Upper Transverse Link with Retaining Bracket and Vehicle Level Control System Sensor Assembly Overview





1 Bolt

2 Bonded Rubber Bearing

• Replacing, refer to => [ Upper Transverse Link Bonded Rubber Bearing ] Upper Transverse Link Bonded Rubber Bearing.

3 Upper Control Arm

• Removing and installing, refer to => [ Upper Transverse Link with Retaining Bracket ] Upper Transverse Link With Retaining Bracket.

4 Bolt

• 30 Nm

5 Retaining Bracket

6 Nut

• Pre-tighten with 8 Nm and tighten with final tightening torque in curb weight position.

• 110 Nm

• Always replace after removal.

• Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] Rear Suspension.

7 Retaining Bracket

8 Wheel Bearing Housing

9 Nut

• 110 Nm

• After loosening the threaded connection of the upper transverse link to the wheel bearing housing, adhesive residue on the pin thread must be removed.

• Always replace after removal.

10 Bolt

• 8 Nm

11 Left Rear Level Control System Sensor (G76) and Right Rear Level Control System Sensor (G77)

• Removing and installing, refer to => [ Level Control System Sensor ] Rear Suspension.

12 Bolt

• 8 Nm