Transmission Speed Sensor: Service and Repair

Transmission Input Speed Sensor

Removing

- Remove air duct - 2 -.





- Remove the bolt - arrows - and the heat shield over the transmission input speed (RPM) sensor (G182).





- Disconnect electrical connector - 1 -.





- Remove the bolt - 2 - and the Transmission Input Speed (Rpm) Sensor (G182) - 3 - from the transmission.

Installing

Install in reverse order, paying attention to the following:

- Insert the Transmission Input Speed (RPM) Sensor (G182) - 3 - with a new O-ring.

- Insert the bolt - 2 - with Sealing Paste (AMV 188 001 02) and tighten. Tightening specification => [ (Item 5) Bolt ] Reverse Gear Assembly Overview.

- Connect connector - 1 -.

- Tighten the heat shield bolts - arrows - to 10 Nm.