Removal and Replacement

Throttle body (electronic throttle module (ETM)), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing the intake hose
Remove the 2 hose clips.
Bend aside the intake hose.

Removing the throttle body





Note! Seal the 2 coolant hoses using hose pinch-off pliers.

Remove:
- the connector from the electronic throttle module (ETM)
- the 2 coolant hoses by releasing the hose clips
- the 2 nuts
- the 2 screws
- the throttle body.
Scrap the gasket.

Installation

Note! For tightening torques, see: Tightening Torque

Installing the throttle body





Install:
- a new gasket
- the throttle body
- the 2 nuts; tighten
- the 2 screws; tighten
- the 2 coolant hoses; tighten the hose clips.
Remove the hose clips.
Attach the connector to the electronic throttle module (ETM).

Installing the intake hose
Install the intake hose. Tighten the 2 hose clips.