Leak Detection Pump: Service and Repair

Leak diagnostic unit, replacing

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However, the essential information in the illustrations is always correct.

Preparation
Remove the carbon filter container according to Carbon filter container, replacing Service and Repair.

Removing the leak diagnostic pump





Remove:
- the hose from the venting pipe
- the connector
- the pump. Pull out the mounting.

Installing the leak diagnostic pump
Connect the hose with the pipe.

Hint: Lubricate the hose using soap solution to facilitate installation.

Connect the connector.

Finishing
Install the carbon filter container. See Carbon filter container, replacing Service and Repair.