Removal and Replacement

Throttle body

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Removing components
Remove the battery ground lead. See: Battery Disconnecting
Remove the air cleaner (ACL) module. See: Air filter module Service and Repair.

Removal

Removing the throttle body (TB)




Disconnect the connector for the throttle body (TB).

Remove:
- the screws for the throttle body (TB). Lift out the throttle body (TB).

Installation

Note! For tightening torques, see Specifications. Tightening Torque

Installing the throttle body (TB)





Install:
- new gasket for the throttle body (TB)
Caution! Tighten the screws crosswise.

the throttle body (TB) using new screws. Tighten. See: Tightening torque Tightening Torque.
Connect the connector to the throttle body (TB).

Installing components
Connect the battery ground lead. See: Battery Disconnecting
Install the air cleaner (ACL) module. See Air filter module Service and Repair.

Finishing

Final checks
Test drive the engine and check the function.