Installing The Dashboard

Installing the dashboard

Installing the dashboard





Note! Before installation: Check that all components are correctly installed.

Note! Two people are required for this operation.

- Align the dashboard carefully.

Install:
- the upper screw by hand
- the screw for the passenger airbag module in the glove compartment
- the remaining screws.
Check the positioning of the dashboard.
Tighten the screw. Tighten to 12 Nm.

Connecting the passenger airbag module




Connect the orange 4-pin connector for the passenger airbag module at the right-hand side of the center console.

Installing the loudspeaker and loudspeaker grille on the passenger side





Install:
- the connector in the loudspeaker
- the loudspeaker in the dashboard.

Note! See the illustration for the location.

Install the rear edge of the loudspeaker grille and press the front edge into position.

Note! Start on the right-hand side.

Installing the dashboard bracket and the hood catch





Install:
- the two connectors from the cable harness for the dashboard
- the blue and brown connectors from the dashboard cable harness
- the bracket and install the upper screw by hand
- the hood catch and the three screws. Tighten to 10 Nm
- the cable from the hood catch
- the cable harness clips in the dashboard
- the screw for the dashboard in the bracket (A)
- The central electronic module (CEM) according to Replacing central electronic module (CEM) Service and Repair.

Installing the loudspeaker and loudspeaker grille on the driver's side





Install:
- the connector in the loudspeaker
- the loudspeakers in the dashboard
- the loudspeaker grille.

Installing components





Install:
- the combined instrument panel according to Driver information module (DIM), installation/removal, component replacement Removal and Replacement
- the comfort control module according to Comfort module Removal and Replacement
- the radio panel according to The radio panel The Radio Panel
- the front center console according to Front center console Front Center Console
- the rear center console according to Rear center console Rear Center Console
- the soundproofing panel according to Driver's side soundproofing Driver's Side Soundproofing and Passenger side soundproofing Passenger Side Soundproofing
- the upper A-post panel according to Upper A-post panel Upper A-Post Panel.

Final check





Note! When all components have been reinstalled and secured, proceed as follows:

- First switch on the ignition
- Connect the battery negative terminal
- Check that the SRS warning light on the dashboard goes out.

Warning! Ensure that nobody is in the car when the battery is being connected.

- Enter the radio code
- Set the clock.