Spacer Ring

Spacer ring

Replacing the spacer ring

Special tools:
999 5604 Punch 999 5604 Punch

Removal




- Remove the clutch driven plate according to Magnetic clutch Magnetic Clutch
- Remove the snap ring
- Remove the spacer ring from the shaft
- Install the special tool 999 5604 Punch 999 5604 Punch in the socket. Turn the tool 90 degrees
- Pull the spacer ring sleeve out to the right
Note! Clean all components with compressed air and a lint-free cloth.

- Check whether any components are worn or dirty. This is particularly important if remnants of the spacer ring remain.

Hint: To replace the spacer ring, see

Installing the spacer ring





Note! Do not touch the inner runner section or the carbon section with your fingers.

- Apply compressor oil on all mating surfaces in the spacer ring
- First install the spacer ring on special tool 999 5604 Punch 999 5604 Punch
- Carefully position the tool and the spacer ring on the shaft. Do not turn it!
- Press the spacer ring into place.

Finishing





Installation
- The wedge in the shaft
- The adjustment rings
- The felt spacer rings and the holder (the holder must be at exactly the same level as the sleeve). Use a drift and a cover.