Pressure Sensor, Replacing

Pressure sensor, replacing

Removing the side cover from the transmission
See Side cover transmission, removing Side Cover Transmission, Removing.

Disconnecting the pressure sensor





Remove:
- the clip for the cable harness from the pressure sensor
- the connector
- the screws.

Note! The upper screw is M10. The two shiny screws are self tapping.

Disconnect the pressure sensor.
Check that all 6 O-rings remain on the pressure sensor.

Installing the pressure sensor




Apply a little automatic transmission fluid to the sensor O-rings.

Install:
- the pressure sensor
- the screws loosely (finger tight).

Note! The upper screw is a M10 screw head. The three long screws are M8. The two shiny short screws are self tapping and should go into the same threads as before.

Tighten the screws lightly crosswise. Then tightenthe black screws. Tighten to 12 Nm.
Then tighten the two self tapping screws. Tighten to 8 Nm.

Install:
- the connector
- the clip for the cable harness for the pressure sensor.

Installing the side cover on the transmission
See Side cover transmission, installing Side Cover Transmission, Installing.