Removal and Replacement

Glass breakage sensor and cable harness

Preparations




Make a note of the anti-theft radio code.
Turn the ignition key to position 0.
Detach the negative lead from the battery.

Removing and installing the glass breakage sensor

Removing glass breakage sensor

Location Of Components, Glass Breakage Sensor Microphone:

Remove:
- the lens for the left-hand interior lighting
- the connector
- the glass breakage sensor from the interior lighting lens using a twisting movement.

Installing glass breakage sensor

Install:
- the glass breakage sensor in the interior lighting lens
- the connector
- the lens for the interior lighting.

Removing and installing the cable harness for the glass breakage sensor

Removing the cable harness for the glass breakage sensor





Remove:
- the soundproofing for the glove compartment according to Passenger side soundproofing Passenger Side Soundproofing
- the lower A-post panel according to Lower A-post panel Lower A-Post Panel
- the upper A-post panel according to Upper A-post panel Upper A-Post Panel
- the sun visor according to Sun visor Sun Visor
- the interior lighting according to Front interior lighting Front Interior Lighting
- the connector for the sensor from the glass breakage control module
- the cable harness for the sensor from the A-post. Pull the cable harness out of the headlining.

Installing the cable harness for the glass breakage sensor

Install:
- the cable harness for the sensor. Press the cable harness into place in the clip on the A-post (tape the cable in the headlining)
- the connector for the sensor on the glass breakage control module
- the interior lighting according to Front interior lighting Front Interior Lighting
- the sun visor according to Sun visor Sun Visor
- the upper A-post panel according to Upper A-post panel Upper A-Post Panel
- the lower A-post panel according to Lower A-post panel Lower A-Post Panel
- the soundproofing for the glove compartment according to Passenger side soundproofing Passenger Side Soundproofing.

Finishing work
Turn the ignition to position II.
Reconnect the battery negative lead.
Enter the anti-theft radio code.
Check the function.
Read off any diagnostic trouble codes (DTCs).