Removal and Replacement

Cable harness, control system, transmission, replacing

Side cover, transmission, removing
See Removing gearbox side cover Removing Gearbox Side Cover

Removing the cable harness





Remove:
- the connectors. No marking is necessary. Each connector is designed for only one component
- the cable harness from its clips and holder
- the large connector. Bend it down slightly and pull it straight out.

Installing the cable harness





Install:
- the large connector
- the connectors on the relevant switches
- the cable harness in the clips and holder
- the temperature sensor in the clip.

Installing the side cover on the transmission
See Installing the gearbox side cover Installing the Gearbox Side Cover