Verification

Verification







Hint: After carrying out the repair, check that the fault has been remedied as follows:
- Ignition off.
- Reinstall the connectors, components etc.
- Control module connected.
- Disconnect the VCT 2000 from the data link connector (DLC).
- Ignition on.
- Test drive the car. Do not switch off the engine after the test drive!
- Connect VCT 2000 to the data link connector (DLC) in the car.

Read off diagnostic trouble codes (DTCs).

Diagnostic trouble code (DTC) 1-1-2 or 1-2-2 should not have been stored.