C15 Checking Central Locking Windings at Door Posts

Switch ignition off.

Remove panels by A-posts, B-posts and LH trunk side as necessary.
Loosen connectors by doorposts.




Connect an ohmmeter by passenger door A-post between position 5 and position 6 of 24-pin connector female section.

Connect an ohmmeter by rear door B-post between position 1 and position 2 of 11-pin connector female section.
Connect an ohmmeter on LH side of luggage compartment between position 11 and position 12 of 24-pin connector male section.

Ohmmeter should read 1-15 Ohms in each case.

If all readings are OK:
Go to step C17. C17 Checking Signal Lead Switches

If any reading is incorrect:
Go to step C16. C16 Checking the Motor Windings In the Door