Governor: Service and Repair

NOTE: Special tools: 5149, 5244.

1. Strip governor as illustrated below, use socket 5244 to disconnect propeller shaft and counterhold 5149 to remove drive flange.

Governor Illustration:

2. Remove spring, screw and retainer, and withdraw governor from shaft.

Governor Assembly:

3. Dismantle, clean and inspect governor components carefully.
- Use fresh cleaning fluid! Clean passages carefully. Dry with compressed air.
- Oil components with ATF fluid when reassembling.

CAUTION: Use correct grade of fluid.

Cover Plate Gasket:

4. Replace gasket under oil passage cover plate.
5. Install governor in reverse order to dismantling.
- Insert screw and retainer.
Torque: 4-5 Nm (3-3.5 ft.lb)
- Install spring. Remount drive flange. Apply locking compound to center bolt. Reconnect propeller shaft.
Torques:
Rear extension housing: 27-47 Nm (20-35 ft.lb)
Drive flange: 40-50 Nm (30-37 ft.lb)
6. Add approx. 1 dl of fluid and check level.

CAUTION: Use correct grade of fluid.