Center and Rear Muffler, Separating

Center and Rear Muffler, Separating

• A separating point has been provided in the connecting pipe for individual replacement of the center or rear muffler.

• The separating point is marked by a depression around the circumference of the exhaust pipe.

Special tools, testers and auxiliary items required

• Chain Pipe Cutter (VAS 6254)

Procedure

- Separate the exhaust pipes at a right angle at the separating point - arrows - using the chain pipe cutter (VAS 6254).






- When installing, position the clamping sleeves - arrows - centrally on the separation point.






- Install the double clamps so that the bolt ends do not project over the lower edge of the double clamp. The clamping sleeve must not touch other components, even at extreme movements of the exhaust system.

• Tightening specification: 35 Nm

- Install the exhaust system free of stress. Refer to => [ Exhaust System, Installing ] Exhaust System, Installing.