Transmission Auxiliary Hydraulic Pump Control Module (J922)

Transmission Auxiliary Hydraulic Pump Control Module (J922)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

The transmission auxiliary hydraulic pump control module is inside the right front wheel housing, attached to the bulkhead behind the right front wheel.

• Read and follow the High Voltage Electrical System General Warnings. Refer to => [ High Voltage Electrical System General Warnings ] Service Precautions.

Removal

- Turn off the ignition and all electrical consumers and remove the ignition key.

- Remove the right front wheel housing liner.

- Open the cap - 1 -, pull the black primary locking mechanism on the bracket and then fold open the bracket.






• The connector automatically ejects with the bracket if folded open and the connector is disconnected.

- Disconnect both connectors - 2 - and - 3 -.

- Remove both bolts - arrows - and remove the transmission auxiliary hydraulic pump control module - 1 -, together with the bracket, from the wheel housing.






Installation

Install in reverse order of removal. Note the following:

- Tighten both bracket bolts to the body to 9 Nm.