Right Flange Shaft Seal

Right Flange Shaft Seal

Special tools, testers and auxiliary items required

• Puller (T10037)

• Thrust Piece (T10049)

• Torque Wrench (5-50 Nm) (V.A.G 1331)

• Torque Wrench (40-200 Nm) (V.A.G 1332)

• Hex Extension (V.A.G 1669) or Socket and Extended Bit (T10107)

Removing

• The transmission is installed.

Follow these instructions exactly to avoid damaging flange shaft needle bearing.

- Remove the drive axle.

- Place a drip tray under the transmission.

- Remove the right flange shaft bolt using the hex extension (V.A.G 1669) or the socket and extended bit (T10107).

- Install the puller (T10037) on the right flange shaft.






- Align the puller with the knurled nut (T10037/1) and the lower support - A - parallel to the flange.

- Remove the flange shaft.

- Pry out the seal.

Installing

- Fill the space between the sealing and dust lip half way with sealing grease for seal (G 052 128 A1).

- Install the seal until seated using the thrust piece (T10049).






- Install the flange shaft while rotating it carefully!

- Fasten the flange shaft with the countersunk bolt and tighten it to 30 Nm.

- Install the drive axle.

- Attach the drive axle heat shield to the bevel box.

- Check the oil level in the bevel box. Refer to => [ Bevel Box Gear Oil Level, Checking and Filling ] Procedures.

- Install the noise insulation, if equipped.

Tightening Specification