B-Pillar Trim

B-Pillar Trim

• Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the same manner.

Removing

- Remove belt anchor. Refer to => [ Belt Anchor ] Belt Anchor.

- Switch off ignition.

- Remove airbag emblem - 2 - and remove screw - 1 -.

- Pull B-pillar trim out of mountings in body and door seal molding.

- Separate the wiring harness from the vent - 3 -.

- Remove trim and pull seat belt through opening in trim.





Installation

- To install, perform the steps used for removal in reverse order.

• Before installing, inspect the securing clips for damage and replace if necessary.

• When installing trim, do not press belt height adjustment button.

• During installation, attach trim from bottom upwards toward belt height adjuster.