ATF Level, Checking

ATF Level, Checking

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1331)

• Used oil collection and extraction unit (V.A.G 1782 )

• Vehicle diagnosis, testing and information system ( VAS 5051)

• Drip tray for workshop hoist (VAS 6208)

• Adapter for filling oil (VAS 6262)

• Adapter (VAS 6262/2)

- Switch off engine.





The ATF temperature should not be more than approx. 30° C at start of test.

• Transmission not in emergency running mode; ATF temperature not above approx. 30 °C

• Vehicle must be standing level

• Selector lever in "P".

- Connect "tester" and continue switching until it is ready for operation => [ VAS 5051, Connecting and Selecting Functions ] Scan Tool Testing and Procedures.

- Press "right" Guided Functions.

- Then select vehicle, the transmission and Check ATF Level.

- Press ->.

- Start engine.

- Raise vehicle.

- Place drip tray under transmission.

- Press ->.

If a test temperature between 35 °C and 45 °C is displayed:

- Remove ATF inspection plug from oil pan.





The ATF present in the overflow tube runs out.





If ATF drips out of drilling:

ATF does not need topping off.

- Install new seal to plug and tighten to 15 Nm. This completes the ATF check.

If no ATF drips out of inspection hole:

- Top off ATF => [ ATF, Filling ] ATF, Filling.