Headlamp Spray Jet Telescoping Cylinder

Headlamp Spray Jet Telescoping Cylinder

CAUTION!
• Turn off the ignition and all electrical consumers.

• Remove ignition key.

Removing

- Remove spray nozzles with cover cap - 1 - up to stop out of bumper cover.





- Unclip cover cap - 1 - from bearings - arrows - on spray nozzle holder.

- Remove the front bumper cover.

- Pull off securing clip - 4 - from hose connection.





- Disconnect hose connection from lift cylinder - 2 -.

- Remove bolt - 1 -.

- Unclip lift cylinder - 2 - from bracket - 3 -.

Installing

Install in reverse order of removal, noting the following:

- The hose to lift cylinder must be clipped into hose bracket.

- Tighten all fasteners according to value in table. Refer to --> [ Windshield Washer System Tightening Specifications ] [1][2]Specifications.

- Bleed headlamp washer system after completing assembly work. Refer to --> [ Headlamp Washer System, Bleeding ] Procedures.