Selector Mechanism Cover

Selector Mechanism Cover

Removing

- Remove the selector lever handle. Refer to => [ Selector Lever Handle ] Selector Lever Handle.

- The procedure for disconnecting the battery must absolutely be obeyed.

- Disconnect the battery Ground (GND) cable with the ignition turned off.

- Remove the selector cover from the center console.

- Disconnect the connector - 1 -.





- Carefully pry up the retaining clips - 2 - on the left and right side of the frame.

Installing

Installation is performed in the reverse order of removal. Pay attention to the following:

- Install the selector over to the center console.

- Connect the battery.

- Install the selector lever handle. Refer to => [ Selector Lever Handle ] Selector Lever Handle.