Clutch, Preparing For Installation

Clutch, Preparing for Installation

Clutch as replacement part





1 Clutch

• Clutch cap of a new clutch is not secured by a securing ring => [ (Item 5) Securing ring ]. It sits slightly "taut" in clutch. Parts of clutch should be prevented from falling out during transport. It can be removed with some caution.

2 Ten securing rings

• Rings have varying thickness. They are stepped in 0.1-mm increments.

• For this, please observe instructions in => [ Clutch, Installing and Adjusting ] Clutch, Installing and Adjusting.

3 Cap (sealing cap) for clutch

• Make sure that inner sealing lip is not damaged => [ Clutch, Installing and Adjusting ] Clutch, Installing and Adjusting.

4 Securing ring

• For cap (sealing cap)

5 Securing ring

• For clutch cap

- Already when removing clutch from packaging, press on clutch cap.





Clutch cap and clutch carrier lying beneath should be prevented from slipping out of inner clutch.

- Check four piston rings - A - for proper seating.





• Ends of the rings must not stand over one another.

Important! Position of clutch cap on clutch.





- Before removing clutch cap, check whether a marking - arrow A - is applied on clutch.

- If there is no marking present, make a color marking yourself. Later, the "tab" of the clutch cap - arrow B - must be installed again on this marked location - arrow A -.

- In case of a new clutch being installed, remove securing ring - 1 -.

- Carefully remove clutch cap from clutch - arrows - and set it aside.





CAUTION!
Prevent the removal or lifting of the clutch carrier Not even slightly! The clutch discs can rotate themselves.

Set down clutch so that it cannot fall over.

This prepares the clutch for installation => [ Clutch, Installing and Adjusting ] Clutch, Installing and Adjusting.