Rear Window Wiper Motor

Rear Window Wiper Motor

CAUTION!
When disconnecting and connecting the battery, always perform the work procedure as described in the repair information --> [ Battery, One-Battery Layout, Disconnecting and Connecting ] Battery, One-Battery Layout, Disconnecting and Connecting. Not adhering to sequence will result in the deactivation of Main Battery Switch -E74- and subsequent damage to electrical system components.

• Rear window must remain closed when removing and installing.

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331/)

Removing

- Remove wiper arm --> [ Rear Window Wiper Arm ] Rear Window Wiper Arm.

- Disconnect battery --> [ Battery, One-Battery Layout, Disconnecting and Connecting ] Battery, One-Battery Layout, Disconnecting and Connecting.

- Remove the lower rear lid trim.

- Disconnect connector - 1 - from Rear Window Wiper Motor (V12) - 3 -.





- Remove nuts - 2 -.

- Remove Motor for rear window wiper (V12) - 3 -.

Installing

Install in reverse order of removal, noting the following:

Motor for rear windshield wiper (V12) must be aligned during installation so that drive pin - 1 - of eccentric lever engages in hole - arrow - of control disc.





• If the position of drive pin - 1 - on eccentric lever does not line up to control disc on Rear Window Wiper Motor (V12) - 2 - - arrow -, turn wiper arm shaft from outside. Do not twist control disc of Rear Window Wiper Motor (V12) - 2 - under any circumstances.

- Place the rear window wiper motor (V12) - 2 - on the rear lid so the drive pin on the eccentric engages in the control disc on the motor.





- Center Motor for rear window wiper (V12) - 2 - to window module - arrow - using a suitable centering drift with 5 mm diameter.

• As a centering drift, e.g. a commercially available drill with a diameter of 5 mm and a length of at least 75 mm can be used. When using a drill, there must be no burrs on the shaft.

- Install the rear window wiper motor (V12) - 2 - on the rear lid with the hex nuts - 1 -.





- Tighten the hex nuts - 1 - to the specification given in the assembly overview --> [ Rear Window Wiper System Assembly Overview ] Rear Window Wiper System Assembly Overview.

- Install the lower rear lid trim.

- Install wiper arm --> [ Rear Window Wiper Arm ] Rear Window Wiper Arm.