Lock Carrier And Front Bumper Reinforcement, Moving to Service Position

Lock carrier and front bumper reinforcement, moving to service position from 10.00

Performing service position





- Remove front bumper. Front Bumper Cover, Assembly Overview
- Remove noise insulation Service and Repair
- Remove air intake air duct between lock carrier -1- and air cleaner at lock carrier.
- Remove bolt -5- on bumper carrier -4- and install Guide rodes 3411 -6- on left and right longitudinal.
- Remove bolts -2- and -3-






- Lock carrier -1- can be pulled forward approx. 10cm on 3411 guide rods -2-

Resetting service position

Resetting lock carrier is same in reverse order.
- Align lock carrier at longitudinal and between fenders

Note: Make sure that pressure hoses for charge air cooler are connected correctly. Hoses and lines must not be pinched.