Removal

2AZ-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL; 2013 MY Corolla [07/2012 -]

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE V-RIBBED BELT Removal

3. REMOVE GENERATOR ASSEMBLY

Removal

4. REMOVE CENTER EXHAUST PIPE ASSEMBLY

(a) Remove the 4 bolts and 2 compression springs.





(b) Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.

(c) Remove the 2 gaskets.

5. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Disconnect the heated oxygen sensor connector.





(b) Remove the 2 bolts, 2 compression springs and front exhaust pipe assembly.

(c) Remove the gasket from the exhaust manifold.

6. REMOVE MANIFOLD STAY

(a) Remove the bolt, nut and manifold stay.





7. REMOVE NO. 2 MANIFOLD STAY

(a) Remove the bolt, nut and No. 2 manifold stay.





8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

(a) Remove the 4 bolts and No. 1 exhaust manifold heat insulator.





9. REMOVE AIR FUEL RATIO SENSOR Removal

10. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

(a) Remove the 5 nuts and exhaust manifold converter sub-assembly.





(b) Remove the gasket.

11. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

(a) Remove the 2 bolts and No. 2 exhaust manifold heat insulator.





12. REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR

(a) Remove the 4 bolts and No. 1 manifold converter insulator.