Installation (from 07/2011)
U340E AUTOMATIC TRANSMISSION / TRANSAXLE: VALVE BODY ASSEMBLY (for Hatchback): INSTALLATION
1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY
(a) Coat a new transaxle case 2nd brake gasket and new transaxle case gasket with Toyota Genuine ATF WS and install them to the transaxle case.
(b) Install the check ball body spring and the check ball body.
(c) Align the groove of the manual valve with the pin of the manual valve lever.
(d) Temporarily install the transmission valve body assembly with the 13 bolts.
Bolt Length
(e) Temporarily install the manual detent spring and the manual detent spring cover with the 2 bolts.
Text in Illustration
Bolt Length
(f) Check that the manual valve lever comes into contact with the center of the roller at the tip of the manual detent spring.
(g) Tighten the 15 bolts.
Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)
2. INSTALL TRANSMISSION WIRE
(a) Install the transmission wire with the lock plate and bolt.
Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)
(b) Connect the 5 connectors to the transmission valve body assembly.
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
(a) Coat a new oil strainer gasket with Toyota Genuine ATF WS and install it to the valve body oil strainer assembly.
(b) Install the valve body oil strainer assembly with the 3 bolts.
Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)
4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
(a) Install the 2 oil cleaner magnets to the automatic transaxle oil pan sub-assembly.
(b) Apply adhesive to 2 or 3 threads on the end of the 2 bolts A.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(c) Install the automatic transaxle oil pan sub-assembly and a new automatic transaxle oil pan gasket with the 19 bolts.
Bolt A - Torque : 7.4 Nm (75 kgf-cm, 65 in-lbf)
Bolt B - Torque : 7.8 Nm (80 kgf-cm, 69 in-lbf)
5. ADD AUTOMATIC TRANSAXLE FLUID
Automatic Transaxle Fluid:
6. INSPECT AUTOMATIC TRANSAXLE FLUID On-Vehicle Inspection
7. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK
8. INSTALL ENGINE UNDER COVER LH