Rear Wheel Alignment (for Hatchback) (from 07/2011)

ALIGNMENT / HANDLING DIAGNOSIS: REAR WHEEL ALIGNMENT (for Hatchback): INSPECTION

NOTICE:
For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:

(a) Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection .

1. INSPECT TIRES Component Tests and General Diagnostics

2. MEASURE VEHICLE HEIGHT Front Wheel Alignment (for Hatchback) (from 07/2011)

3. INSPECT CAMBER

(a) Install the camber-caster-kingpin gauge and position the rear wheel on the alignment tester.

(b) Inspect the camber.

Camber (Unloaded Vehicle)





NOTICE:
The tolerance for the difference between the left and right wheels is 30' (0.5°) or less for both cambers. If the camber is not within the specified range, inspect the suspension parts and replace them if necessary.

4. INSPECT TOE-IN





Text in Illustration





Toe-in (Unloaded Vehicle)





If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.

5. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION