Installation (from 07/2011)

U340E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH (for Hatchback): INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch assembly to the automatic transaxle assembly.

(b) Temporarily install the 2 bolts.

(c) Replace the lock plate with a new one and install the nut, lock plate and washer.

Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)

(d) Temporarily install the control shaft lever.

(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.





(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.





Text in Illustration





(h) Hold the switch in this position and tighten the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(i) Using a screwdriver, stake the nut with the lock plate.





(j) Install the control shaft lever with the nut and washer.

Torque : 13 Nm (130 kgf-cm, 9 ft-lbf)

(k) Connect the connector to the park/neutral position switch assembly.

2. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Install the transmission control cable assembly to the control shaft lever with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

Text in Illustration





(b) Install the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.

NOTICE:
Make sure that the marking on the cable is aligned with the slit in the No. 1 transmission control cable bracket before installing the cable.

3. ADJUST SHIFT LEVER POSITION

Adjustments

4. INSPECT SHIFT LEVER POSITION Initial Inspection and Diagnostic Overview

5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY On-Vehicle Inspection

6. INSTALL ENGINE UNDER COVER LH