Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: FRONT PASSENGER AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL NO. 3 INSTRUMENT PANEL WIRE

(a) Connect the 2 airbag connectors to the front passenger airbag assembly.

NOTICE:
* When connecting any airbag connector, take care not to damage the airbag wire harness.
* Be sure to only connect the connectors to each corresponding color.

(b) Push in the 2 locks to install the 2 airbag connectors.

(c) Connect the No. 3 instrument panel wire to the front passenger airbag assembly clamp.

(d) Engage the clamp to install the No. 3 instrument panel wire to the front passenger airbag assembly.

2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

(a) Engage the 3 hooks.

(b) Push the front passenger airbag assembly to engage the 3 hooks.

(d) Install the 2 clamps to the front passenger airbag assembly.

3. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY Installation

4. CONNECT NO. 3 INSTRUMENT PANEL WIRE

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the connector.

NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

HINT
Refer to the procedure from Install Center Instrument Cluster Finish Panel Garnish Installation.

6. PERFORM DIAGNOSTIC SYSTEM CHECK

(a) Perform a diagnostic system check DTC Check / Clear.