Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Removal

2. REMOVE REAR CONSOLE BOX ASSEMBLY

Removal

3. REMOVE FRONT DOOR SCUFF PLATE LH Removal

4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH Removal

5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH Removal

6. REMOVE INSTRUMENT SIDE PANEL LH Removal

7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Removal

8. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY Removal

9. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal

10. REMOVE BOX BOTTOM MAT Removal

11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

12. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal

13. REMOVE CONSOLE BOX INSERT Removal

14. REMOVE FLOOR CARPET BRACKET LH Removal

15. REMOVE FLOOR CARPET BRACKET RH Removal

16. REMOVE NO. 1 CONSOLE BOX DUCT (w/ Rear Register Duct) Removal

17. REMOVE AIRBAG SENSOR ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Turn back the carpet.

(d) Disconnect the connectors from the airbag sensor assembly as shown in the illustration.





NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(e) Remove the 3 bolts and airbag sensor assembly.