Installation

EXTERIOR PANELS / TRIM: FRONT BUMPER: INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY

(a) Move the front bumper assembly into position and install the 3 clips.

(b) Pull back the side of the front bumper assembly and connect each connector.

NOTICE:
Do not apply excessive force when pulling back the side of the front bumper assembly.

HINT
Use the same procedure for the RH side and LH side.

(c) Engage the 3 claws to install the front bumper assembly.





HINT
Use the same procedure for the RH side and LH side.

(d) Install the 6 screws.

(e) Install the pin hold clip as shown in the illustration.





Text in Illustration





NOTICE:
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.

HINT
Use the same procedure for the RH side and LH side.

(f) Install the clip.

HINT
Use the same procedure for the RH side and LH side.

2. INSTALL RADIATOR GRILLE SUB-ASSEMBLY

Installation

3. ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)

Adjustments