Guide Lines are Displayed with Vehicle Center Line

PARK ASSIST / MONITORING: PARKING ASSIST MONITOR SYSTEM: Guide Lines are Displayed with Vehicle Center Line
- Guide Lines are Displayed with Vehicle Center Line

DESCRIPTION

The rear television camera assembly can create parking guide lines. Because this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the rear television camera assembly is disabled.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point Initialization.
* Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Calibration.

PROCEDURE

1. CHECK SCREEN MODE

(a) Check the back guide monitor screen.





Result:





Text in Illustration





B -- USE SIMULATION METHOD TO CHECK (A WIRE MAY BE OPEN) Electronic Circuit Inspection Procedure
A -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)

(a) Disconnect the T6 connector from the rear television camera assembly.





(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE REAR TELEVISION CAMERA ASSEMBLY Removal