Installation

2AZ-FXE ENGINE CONTROL SYSTEM: THROTTLE BODY: INSTALLATION

1. INSTALL THROTTLE BODY

(a) Install a new gasket onto the intake manifold.

(b) Connect the purge line hose to the throttle body.

(c) Connect the water by-pass hose to the throttle body.

(d) Connect the No. 2 water by-pass hose to the throttle body.

(e) Install the throttle body and fuel pipe support with the 4 bolts.

Torque : 30 Nm (305 kgf-cm, 22 ft-lbf)

(f) Connect the fuel tube into the clamp.

(g) Connect the throttle position sensor connector.

(h) Connect the wire harness clamp.

2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

(a) Install the air cleaner filter element onto the air cleaner case.

(b) Insert the hinges, and then install the air cleaner cap sub-assembly with the 2 bolts.

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

Text in Illustration

NOTICE:
* Match each concave area of the air cleaner hose with the bolt of the throttle body.
* Make sure that the hose clamp is at the correct angle.

(d) Connect the No. 2 ventilation hose to the cylinder head cover.

(e) Connect the purge line hose to the clamp*1.

(f) Connect the 2 purge VSV vacuum hoses*2.

(g) Connect the purge VSV connector*3.

(h) Connect the mass air flow meter connector*4.

3. ADD COOLANT (for Engine) Coolant (for Engine)

4. INSPECT FOR COOLANT LEAK (for Engine) Testing and Inspection

5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation