Installation

EXTERIOR: FRONT BUMPER: INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY

(a) w/ Fog Light:

(1) Connect each connector.

(b) Engage the 2 claws.





HINT
Use the same procedure for the RH side and LH side.

(c) Install the pin hold clip.





NOTICE:
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertically.

HINT
Use the same procedure for the RH side and LH side.

(d) Remove the applied protective tape on front bumper assembly.





2. VEHICLE PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

3. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) Adjustments

4. INSPECT FOG LIGHT AIMING (w/ Fog Light) Adjustments

5. ADJUST FOG LIGHT AIMING (w/ Fog Light) Adjustments