Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system Service Precautions.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG Disassembly

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL Disassembly

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY Disassembly

6. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

7. REMOVE REAR DOOR GLASS RUN Disassembly

8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Disassembly

9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

10. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY Disassembly

11. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and the rear power window regulator motor assembly.