Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Vehicle Stability Control System





BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
Turn the ignition switch off before removing any parts.

HINT
* If no malfunction is found when inspecting parts, inspect the skid control ECU and ground points for poor connect.
* If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the applicable Diagnostic Trouble Code Test.
* When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
* For DTCs indicated by the warning light or indicator light, refer to the DTC charts in DTC Check/Clear.
* Inspect the fuses and relays before investigating the trouble areas as shown in the table below.

ABS DTC

C0226-C1361:





C1381-C1414:





C1415-C1428:





C1442 / U0073-U0124:






*1 to *3:

Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:

* *1:

* Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.

* Clear the DTCs.

* *2:

* Turn the ignition switch to ON.

* Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.

* Drive the vehicle at the vehicle speed of 50 km/h (31 mph) and depress and hold the brake pedal firmly for approximately 3 seconds.

* Repeat the above operation 3 times or more and check that the ABS warning light goes off.

* Clear the DTCs.

* *3:

* Turn the ignition switch to ON.

* Depress the brake pedal.

* Clear the DTCs.

HINT
In some cases, the Techstream cannot be used when the ABS warning light remains on.

VSC DTC

C1201-C1440:





C1443-C1445 / U0100-U0126:





HINT
In some cases, the Techstream cannot be used when the VSC OFF indicator light remains on.

ABS Test Mode DTC

ABS Test Mode DTC:





VSC Test Mode DTC: