Vehicle Stability Control System (for BOSCH Made)
BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM (for BOSCH Made): DIAGNOSTIC TROUBLE CODE CHART
* If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the respective "DTC Code" in the DTC chart.
* Inspect the fuse and relay before investigating the trouble areas as shown in the table below.
ABS DTC
C0200/31-C0226/21:
C0236/22-C1228/28:
C1237/37-C1271/71:
C1272/72-C1330/35:
C1331/36-C1339/39 / U0073/94:
(*1, *2):
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
* (*1):
* Drive the vehicle at 12 mph (20 km/h) for 30 seconds or more and check that the ABS warning light goes off.
* Clear the DTC.
* (*2):
* Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
* Drive the vehicle at the vehicle speed of 31 mph (50 km/h) and keep depressing the brake pedal strongly for approximately 3 seconds.
* Repeat the above operation 3 times or more and check that the ABS warning light goes off.
* Clear the DTC.
HINT
In some cases, Techstream cannot be used when the ABS warning light remains on.
VSC DTC