P2451

2AZ-FXE ENGINE CONTROL SYSTEM: SFI SYSTEM: P2450,P2451: Fuel Vapor-containment Valve Stuck Open
P2451 - Fuel Vapor-containment Valve Stuck Close

DTC SUMMARY





DESCRIPTION

Refer to EVAP System Component Tests and General Diagnostics.

MONITOR DESCRIPTION

* P2450: Fuel vapor-containment valve (FVCV) stuck open

* During sequence C, the vacuum pump creates vacuum pressure in the EVAP system. If the pressure in the fuel tank drops, the ECM (included in the hybrid vehicle control ECU) determines that the fuel vapor-containment valve is stuck open. The ECM then illuminates the MIL and sets the DTC. (This DTC is set according to 2-trip detection logic.)

* P2451: Fuel vapor-containment valve (FVCV) stuck closed (vent)

* During sequence G, the fuel vapor-containment valve opens to allow vacuum pressure generated by the vacuum pump into the fuel tank. If the pressure in the fuel tank does not drop, the ECM determines that the fuel vapor-containment valve is stuck closed. The ECM then illuminates the MIL and sets the DTC. (This DTC is set according to 2-trip detection logic.)

* During sequence I, the fuel vapor-containment valve opens to allow atmospheric pressure into the fuel tank. If there is no change in fuel tank pressure, the ECM determines that the fuel vapor-containment valve is stuck closed. The ECM then illuminates the MIL and sets the DTC. (This DTC is set according to 2-trip detection logic.)





MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





Example of restart time:

Example of restart time::

Key-off monitor sequence 1 to 15

1. Atmospheric pressure measurement

1. Atmospheric pressure measurement:

2. First reference pressure measurement

2. First reference pressure measurement:

3. Vent valve stuck closed check

3. Vent valve stuck closed check:

4. Vacuum introduction for canister

4. Vacuum introduction for canister:

5. Purge VSV stuck closed check

5. Purge VSV stuck closed check:

6. Second reference pressure measurement

6. Second reference pressure measurement:

7. Canister leak

7. Canister leak:

8. Fuel vapor-containment valve (FVCV stuck closed check)

8. Fuel vapor-containment valve (FVCV stuck closed check):

9. Vacuum introduction for fuel tank

9. Vacuum introduction for fuel tank:

10. FVCV stuck closed check

10. FVCV stuck closed check:

11. FTP sensor stuck check

11. FTP sensor stuck check:

12. Third reference pressure measurement

12. Third reference pressure measurement:

13. Fuel tank leak check

13. Fuel tank leak check:

14. FTP sensor stuck check

14. FTP sensor stuck check:

15. Atmospheric pressure measurement

15. Atmospheric pressure measurement:

TYPICAL MALFUNCTION THRESHOLDS

"Saturated" indicates that the EVAP pressure change is less than 0.286 kPa (2.14 mmHg) in 60 seconds.

P2450: Fuel vapor-containment valve stuck open

P2450: Fuel vapor-containment valve stuck open:

P2451: Fuel vapor-containment valve stuck closed

P2451: Fuel vapor-containment valve stuck closed:

MONITOR RESULT

Refer to EVAP System Component Tests and General Diagnostics.

INSPECTION PROCEDURE

Refer to EVAP System Component Tests and General Diagnostics.