Slip Indicator Light Does Not Come On

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: Slip Indicator Light does not Come ON
- Slip Indicator Light does not Come ON

DESCRIPTION

Slip Indicator Light Remains On.

WIRING DIAGRAM

Slip Indicator Light Remains On.

INSPECTION PROCEDURE

NOTICE:
When replacing the ABS & TRACTION actuator assembly, perform zero point calibration Programming and Relearning.

PROCEDURE

1. INSPECT CAN COMMUNICATION SYSTEM

(a) Check if the CAN communication system DTC is output Diagnosis System.

Result:





B -- REPAIR CAN COMMUNICATION SYSTEM
A -- Continue to next step.

2. INSPECT MULTIPLEX COMMUNICATION SYSTEM

(a) Check if the multiplex communication system DTC is output Reading and Clearing Diagnostic Trouble Codes.

Result:





B -- REPAIR MULTIPLEX COMMUNICATION SYSTEM
A -- Continue to next step.

3. INSPECT SLIP INDICATOR LIGHT

(a) Connect Techstream to the DLC3.

(b) Start the engine.

(c) Select "ACTIVE TEST" on Techstream.

ACTIVE TEST: ABS / VSC / TRAC

ACTIVE TEST: ABS / VSC / TRAC:

(d) Check that "ON" and "OFF" of the SLIP indicator light are indicated on the combination meter when using Techstream.

OK:

The SLIP indicator light turns on or off in accordance with Techstream.

HINT
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part Problem Symptoms Table.

NG -- INSPECT COMBINATION METER ASSEMBLY

OK -- REPLACE ABS & TRACTION ACTUATOR ASSEMBLY

4. INSPECT COMBINATION METER ASSEMBLY

(a) Check the combination meter assembly How To Proceed With Troubleshooting.

HINT
If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step Problem Symptoms Table.

NG -- REPLACE COMBINATION METER ASSEMBLY

OK -- END