Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Installation








E351 MANUAL TRANSAXLE: MANUAL TRANSAXLE ASSEMBLY:

INSTALLATION

1. INSTALL MANUAL TRANSAXLE ASSEMBLY
(a) Align the input shaft with the clutch disc and install the transaxle to the engine.





(b) Install the 10 bolts.
Bolt A - Torque: 64 Nm (653 kgf-cm, 47 ft-lbf)
Bolt B - Torque: 46 Nm (470 kgf-cm, 34 ft-lbf)
Bolt C - Torque: 44 Nm (449 kgf-cm, 32 ft-lbf)
2. INSTALL ENGINE MOUNTING INSULATOR LH





(a) Install the engine mounting insulator LH with the 4 bolts.
Torque: 64 Nm (653 kgf-cm, 47 ft-lbf)

HINT: Tighten them in order: A, B, C and D.

3. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET





(a) Install the No. 1 exhaust pipe support bracket with the 2 bolts.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
4. INSTALL MANUAL TRANSMISSION CASE PROTECTOR





(a) Install the manual transmission case protector with the 2 bolts.
Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)
5. INSTALL FRONT ENGINE MOUNTING BRACKET





(a) Install the front engine mounting bracket with the 3 bolts.
Torque: 64 Nm (653 kgf-cm, 47 ft-lbf)
6. INSTALL STARTER ASSEMBLY





(a) Install the starter assembly with the 2 bolts.
Torque: 39 Nm (398 kgf-cm, 29 ft-lbf)
7. INSTALL WIRE HARNESS CLAMP





(a) Install the wire harness clamp with the bolt.
Torque: 8.4 Nm (86 kgf-cm, 74 in-lbf)
8. INSTALL NO. 3 ENGINE WIRE





(a) Connect the No. 3 engine wire with the bolt.
Torque: 12 Nm (120 kgf-cm, 9 ft-lbf)
9. CONNECT WIRE HARNESS
(a) Install the wire harness clamp.
(b) Connect the backup light switch connector, speedometer sensor connector and starter connector.
10. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

HINT: (Reassembly)

11. INSTALL CLUTCH ACCUMULATOR ASSEMBLY

HINT: (Installation)

12. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

HINT: (Installation)

13. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT: (Installation)

14. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT: (Installation)