Removal

POWER STEERING: 2AZ-FE VANE PUMP:

REMOVAL

NOTICE:
- Do not overtighten when using a vise.
- When installing, coat the parts indicated by arrows with power steering fluid (Components).

1. REMOVE FRONT WHEEL RH
2. DRAIN POWER STEERING FLUID
3. REMOVE FRONT FENDER APRON SEAL RH
4. REMOVE FAN AND GENERATOR V BELT (Removal)

5. DISCONNECT OIL RESERVOIR TO PUMP HOSE NO.1
(a) Remove the clip and disconnect the oil reservoir to pump hose No.1.

NOTE: Take care not to spill fluid on the V belt.

6. DISCONNECT PRESSURE FEED TUBE ASSEMBLY





(a) Using a wrench (27 mm) to hold the pressure port union, remove the union bolt and the gasket.
7. REMOVE VANE PUMP ASSEMBLY





(a) Disconnect the connector from the oil pressure switch.
(b) Using SST and a deep socket wrench (14 mm), loosen bolt A.
SST: 09249-63010

HINT: Do not remove bolt A.

(c) Remove bolt B and the vane pump assembly.