Installation

WIPER AND WASHER: REAR WIPER MOTOR:

COMPONENTS

INSTALLATION

1. INSTALL REAR WIPER MOTOR GROMMET

(a) Install the rear wiper motor grommet as shown in the illustration.
2. INSTALL REAR WIPER MOTOR ASSEMBLY

(a) Install the rear wiper motor assembly with the 3 bolts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Install the rear wiper motor & bracket with the 3 screws.

(f) Install the rear wiper motor & bracket assembly with shaft cover assembly with the 2 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
3. INSTALL W/WASHER PACKING NUT REAR WIPER LINK PIVOT

(a) Using a deep socket wrench (24mm), install the w/washer packing nut rear wiper link pivot with the nut.
Torque: 7.0 Nm (71 kgf-cm, 62 in-lbf)
4. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

(a) Clean the wiper arm serrations.
(b) Clean the rear wiper pivot serrations with a wire brush (when reinstalling).

(c) Install the RR wiper arm & blade assembly in the position shown in the illustration.
(d) Install the RR wiper arm & blade assembly with the nut.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)

HINT: Hold down the arm hinge by hand in order to fasten the nut.

(e) Operate the wiper while spraying water or washer fluid on the glass. Ensure that the wiper functions properly and there is no interference with the body.