Installation

POWER STEERING: VANE PUMP:

COMPONENTS





INSTALLATION

1. INSTALL VANE PUMP ASSEMBLY





(a) Install the vane pump assembly with the 2 bolts and nuts.
Torque: 37 Nm (380 kgf-cm, 27 ft-lbf)
(b) Connect the oil pressure switch connector.

NOTE: Be careful that the oil does not adhere to the connector.

2. INSTALL PRESSURE FEED TUBE ASSEMBLY





(a) Using SST, connect the pressure feed tube assembly.
SST: 09023-38401
Torque: 41 Nm (420 kgf-cm, 30 ft-lbf)

- Use a torque wrench with a fulcrum length of 345 mm (13.58 in.).
- This torque value is effective when SST is parallel to a torque wrench.

(b) Connect the pressure feed tube clamp with the bolt.
Torque: 7.8 Nm (80 kgf-cm, 69 ft-lbf)
3. CONNECT OIL RESERVOIR TO PUMP HOSE NO. 1
(a) Connect the oil reservoir to pump hose No. 1 with the clip.
4. INSTALL FAN AND GENERATOR V BELT
5. INSTALL FRONT WHEEL RH
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
6. ADD POWER STEERING FLUID
7. BLEED POWER STEERING FLUID
(Power Steering System)
8. INSPECT FOR POWER STEERING FLUID LEAK
9. INSTALL ENGINE UNDER COVER RH