Fuel Receiver Gauge Malfunction

METER: METER / GAUGE SYSTEM: Fuel Receiver Gauge Malfunction

Fuel Receiver Gauge Malfunction

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS OR CONNECTOR

(a) Disconnect the F10 connector from the fuel sender gauge assembly.
(b) Check the meter indicator conditions according to the table below.
Standard:

NG -- CHECK HARNESS AND CONNECTOR (FUEL SENDER GAUGE ASSEMBLY - COMBINATION METER)
OK -- Continue to next step.
2. INSPECT FUEL SENDER GAUGE ASSEMBLY
(a) Remove the fuel sender gauge assembly.

(b) Check that the float position is between E and F.

(c) Measure the resistance between terminals 2 and 3 of the connector according to the value(s) in the table below.
Standard resistance:

NG -- REPLACE FUEL SENDER GAUGE ASSEMBLY
OK -- REPLACE COMBINATION METER ASSEMBLY
3. CHECK HARNESS AND CONNECTOR (FUEL SENDER GAUGE ASSEMBLY - COMBINATION METER)

(a) Disconnect the C11 and F10 connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE COMBINATION METER ASSEMBLY