Radio Receiver Power Source Circuit

AUDIO AND VISUAL SYSTEM: Radio Receiver Power Source Circuit

Radio Receiver Power Source Circuit

DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (BATTERY - RADIO RECEIVER)





(a) Disconnect the radio receiver R16 connector.
(b) Measure the resistance according to the values in the table below.
Standard resistance:





*1: Separate Type Amplifier
*2: Built-in Type Amplifier
(c) Measure the voltage according to the values in the table below.
Standard voltage:





*1: Separate Type Amplifier
*2: Built-in Type Amplifier
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE