Removal

1ZZ-FE EXHAUST: EXHAUST PIPE: REMOVAL

REMOVAL

1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE HEATED OXYGEN SENSOR





(a) Using a clip remover, remove the clip [A].
(b) Pull off the floor carpet front [B].





(c) Disconnect the heated oxygen sensor connector [C].
(d) Remove the grommet [D], then pull the connector to the outside if the vehicle.





(e) Using SST, remove the heated oxygen sensor.
SST: 09224-00010
3. REMOVE EXHAUST PIPE ASSEMBLY TAIL
(a) Remove the 2 bolts and 2 compression springs [A].
(b) Remove the exhaust pipe tail from the 2 exhaust pipe supports No. 4 [B].









(c) Remove the gasket from the exhaust pipe assembly front.
4. REMOVE FLOOR PANEL BRACE FRONT





(a) Remove the 2 nuts and floor panel brace front.
5. REMOVE EXHAUST PIPE ASSEMBLY FRONT
(a) Remove the 2 bolts and 2 compression springs [A].
(b) Remove the exhaust pipe front from the 2 exhaust pipe supports No. 4 [B].









(c) Remove the gasket from the exhaust manifold.