Removal

PARKING BRAKE: PARKING BRAKE CABLE: REMOVAL

REMOVAL

HINT: For parking brake cable assembly No. 2, perform the same procedure to the parking brake cable assembly No. 3.

1. REMOVE REAR WHEEL
2. DRAIN BRAKE FLUID

NOTE: Wash brake fluid off immediately if it adheres to any painted surface.

3. SEPARATE PARKING BRAKE SHOE STRUT SET LH (for TMC Made) (Disassembly)

4. REMOVE FRONT BRAKE SHOE (for TMC Made) (Disassembly)

5. REMOVE PARKING BRAKE SHOE STRUT SET LH (for TMC Made)
6. REMOVE AUTOMATIC ADJUST LEVER LH (for TMC Made) (Disassembly)

7. REMOVE REAR BRAKE SHOE (for TMC Made) (Disassembly)

8. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (for TMMC Made) (Disassembly)

9. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH (for TMMC Made) (Disassembly)

10. REMOVE FRONT BRAKE SHOE (for TMMC Made) (Disassembly)

11. REMOVE PARKING BRAKE SHOE STRUT SET LH (for TMMC Made)
12. REMOVE REAR BRAKE SHOE (for TMMC Made) (Disassembly)

13. SEPARATE PARKING BRAKE CABLE ASSEMBLY NO. 3





(a) Remove the bolt, and disconnect the parking brake cable assembly No. 3 from the backing plate.
14. REMOVE EXHAUST PIPE ASSEMBLY FRONT (Removal)

15. REMOVE FRONT FLOOR HEAT INSULATOR NO. 1





(a) Remove the 3 nuts and front floor heat insulator No. 1.
16. REMOVE FRONT FLOOR HEAT INSULATOR NO. 2





(a) Remove the 2 nuts and front floor heat insulator No. 2.
17. REMOVE PARKING BRAKE CABLE ASSEMBLY NO. 1
(a) Disconnect the parking brake cable assembly No. 1 from the equalizer and remove the parking brake cable assembly No. 1.
18. REMOVE FUEL TANK PROTECTOR NO. 1
(a) Remove the 5 nuts and fuel tank protector No. 1.
19. REMOVE PARKING BRAKE CABLE ASSEMBLY NO. 3





(a) Using a clip remover, disconnect the skid control sensor wire harness clip from the clamp.
(b) Remove the 4 bolts and cable retainer from the body.
(c) Disconnect the parking brake cable assembly No. 3 from the equalizer, and remove the parking brake cable assembly No. 3.