Removal

HYBRID BATTERY CONTROL: BATTERY SMART UNIT:

REMOVAL

1. PRECAUTION
Service Precautions
2. CHECK FOR DTCS Removal

3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL Removal

5. REMOVE SERVICE PLUG GRIP Removal

6. REMOVE NO. 2 ENGINE ROOM SIDE LH COVER Removal

7. REMOVE CONNECTOR COVER ASSEMBLY Removal

8. CHECK TERMINAL VOLTAGE Removal

9. INSTALL CONNECTOR COVER ASSEMBLY Installation

10. INSTALL NO. 2 ENGINE ROOM SIDE LH COVER Installation

11. REMOVE REAR SEAT HEADREST ASSEMBLY
12. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY
13. REMOVE REAR SEAT CUSHION ASSEMBLY

14. REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY RH

15. REMOVE SEPARATE TYPE REAR SEATBACK ASSEMBLY LH

16. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER Removal

17. REMOVE NO. 5 HV BATTERY INTAKE DUCT Removal

18. REMOVE WIRE HARNESS CLAMP BRACKET Removal

19. REMOVE UPPER BATTERY CARRIER SUB-ASSEMBLY Removal

20. DISCONNECT FRAME WIRE Removal

21. REMOVE NO. 1 BATTERY COVER LID Removal

22. REMOVE NO. 5 BATTERY CARRIER PANEL Removal

23. REMOVE FILTER NOISE CAPACITOR Removal

24. REMOVE HV RELAY ASSEMBLY Removal

25. REMOVE BATTERY SMART UNIT






(a) Remove the bolt and battery smart unit.
CAUTION: Wear insulated gloves.





(b) Disconnect the 3 connectors from the battery smart unit.
CAUTION: Wear insulated gloves.