Removal

SEAT: FRONT SEAT ASSEMBLY (for Power Seat): REMOVAL

REMOVAL
CAUTION:
- Always wear safety gloves because the edges of the seatback frame and seat adjuster are sharp and may cause injury.
- Work must be started more than 90 seconds after the ignition switch is turned off and the negative (-) terminal cable is disconnected from the battery.
(The SRS is equipped with a back-up power source. If work is started within 90 seconds after disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)
HINT:
- Installation is in the reverse order of removal. However, special points concerning installation are indicated.
- Use the same procedures for the RH side and LH side.
- When removing/installing or overhauling the passenger seat, check the passenger occupant classification system and perform zero point calibration
Programming and Relearning.

1. REMOVE SEAT TRACK BRACKET COVER OUTER FRONT LH






(a) Move the front LH seat assembly to the rearmost position by operating the power seat switch knob.
(b) Disengage the 2 claws and remove the seat track bracket cover outer front LH.
2. REMOVE SEAT TRACK BRACKET COVER INNER FRONT LH






(a) Disengage the 2 claws and remove the seat track bracket cover inner front LH.
3. REMOVE FRONT SEAT TRACK COVER LH REAR OUTER






(a) Move the front LH seat assembly fully forward by operating the power seat switch knob.
(b) Disengage the 2 claws and remove the front seat track cover LH rear outer.
4. REMOVE REAR SEAT TRACK BRACKET COVER INNER LH






(a) Disengage the 2 claws and remove the rear seat track bracket cover inner LH.
5. REMOVE FRONT LH SEAT ASSEMBLY






(a) Set the front vertical in the most upright position.
(b) Move the front LH seat assembly to the rearmost position by operating the power seat switch knob.
(c) Remove the 2 bolts on the front side.
(d) Move the front LH seat assembly fully forward by operating the power seat switch knob.
(e) Remove the 2 bolts on the rear side.
(f) Disconnect the negative battery terminal Service Precautions.
(g) Disconnect the connectors and clamp.
(h) Remove the front LH seat assembly.